Tabla de contenido
Publicidad
SM 2610956994 04-09:2610956994 8-08 3305 4/29/09 2:14 PM Page 34
Adjustments
Removal and Installation
of the blade
Disconnect plug from power source before
W RNING
performing any assembly, adjustment or repair
to avoid possible injury.
NOTE: Clean blade of any excess oil before installation.
1.
Remove the table insert 1 by unscrewing the two screws 2
(Fig. 14).
2.
Raise the blade 3 to the maximum height by turning the
control wheel 4 counterclockwise (Fig. 15).
3.
Remove the arbor nut 5 and flange 6 (Fig. 16).
4.
Clean any sawdust from both blade collars before installing
the blade. Install a 10" (25.4 cm) blade. Install the saw blade
onto the the arbor with the blade teeth pointing toward the
front of the saw.
To avoid injury, do not use a blade larger or
W RNING
smaller than 10
5.
Install the flange 6 against the blade 3 and thread the arbor nut
5 as far as possible by hand. Ensure that the blade is flush
against the inner blade flange (Fig. 16).
6.
To tighten the arbor nut 5, use the open-end wrench 7 and
align the wrench jaws on the flats of the flange to keep the
arbor from turning. Place the box-end wrench 8 on the arbor
nut 5 and turn clockwise (to the rear of the saw table) (Fig.
17).
7.
Install the table insert 1 in the table recess. Insert the screws 2
through the holes and tighten (Figure 14).
To avoid injury from a thrown workpiece, blade
W RNING
part, or blade contact, never operate the saw
without the proper insert in place. Use the table insert when
sawing. Use the dado insert when using a dado blade.
Using Carbide-Tipped blades
Handle carbide-tipped blades carefully. Carbide
W RNING
is very brittle and can be easily damaged. Use
caution when you install, use or store the blades. Do not use a
carbide-tipped blade that is bent or has bent teeth, or if the blade
has cracks, is broken, or has missing/loose carbide tips. Do not
operate a carbide-tipped blade faster than its recommended
speed.
Read, understand and follow all warnings and instructions
provided with your carbide-tipped blades.
diameter and 5/8
arbor.
"
"
7
34.
FIG. 14
1
2
FIG. 15
3
4
FIG. 16
5
6
FIG. 17
8
5
Publicidad
Tabla de contenido
