MRA BMW F850GS 2018 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
4 Plastic washers 12 x 5 x 0,5mm
4 Neoprene washers 16 x 4.5 x 4mm
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Dismantle the original windscreen.
3. Insert the original mounting screws with the provided thin neoprene washers
[10634] into the holes in the MRA windscreen.
4. Afterwards, attach the thicker plastic washers [10635] from the rear.
5. Mount the MRA windscreen to the motorcycle and tighten the screws.
Important information:
The handlebar must be in neutral position! This means, the marking at the
handlebar (small dot) must be aligned with the end of the lower handlebar
support (=factory setting). If the handlebar is turned too far to the front, the
handguards get into contact with the windscreen.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW F850GS 18-
Article No..
--- Torx 25
10635
10634
3
Required tools