Peg-Perego VIAGGIO FF105 Instrucciones De Uso página 21

• Never put hot drinks in the cup holder, if present.
Components of the Product
Inspect the content of the package and contact
Customer Care if any items are missing.
The child car seat includes:
a) Booster Cushion
b) Headrest
c) Harness tension release button
d) Adjustment of belt tightness
e) Knob for adjusting inclination
f ) Full 5-point safety harness with shoulder pads
g) Belt clip
h) Lever for release from base
i) Headrest height adjustment button
l) Instruction manual compartment.
m) Headrest covered with shock-absorbing expanded
polystyrene (EPS)
n) Cup holder.
o) Kinetic Pods: side protections
The car seat is ready for use: no assembly required.
Instructions for use with base
1 Attach Viaggio FF105 in forward facing position
by positioning it onto the i-Size Base on the
attachment points and pushing down until it clicks
(fig_a). Check that the red/green indicators, near
the leg of the base, are in green position (fig_b).
2 To detach Viaggio FF105 from the i-Size Base, pull
the lever that is in the front and under the seat
and, at the same time, lift the seat.
3 To adjust the car seat's inclination, rotate the knob
until the seat is in the desired position
4 Viaggio FF105 uses a 5-point harness to protect
your child. Before placing the child on the seat.
Act on the central release button and pull the
straps, loosening the belts (fig_a). Do not pull the
shoulder pads.
Open the chest clip following the procedure
shown (fig_b), unfasten the safety belts by acting
on the red button of the crotch strap's buckle
(fig_c).
5 Attach the buckles to the side elastics and pull the
crotch strap towards the front of the seat to make
room for the child. Make sure the sitting area is free.
6 The headrest must be adjusted to match the
child's height. There are several positions.
To switch from a low to a higher position: pull the
tongue at the centre of the head rest (1) upward;
the head rest simultaneously lifts (2).
To switch from a high position to a lower one: pull
the lever in the upper central part of the headrest
upwards and, at the same time, push the headrest
down to the desired position.
When you have finished, slightly move the
headrest to check it is properly locked into place.
7 Place the child in the car seat and arrange the harness
over the child' s shoulders and waist. The correct
21