Peg-Perego VIAGGIO FF105 Instrucciones De Uso página 22

height for the safety belts is when the belt slots on the
backrest are at the same height of the shoulders or
above (green area), as shown in the picture.
Make sure the straps are not in the red area.
8 Attach the safety straps by overlapping the two
belts (1) and inserting the metal hooks into the
crotch strap buckle until it clicks (2). Attach the
belt clip on the chest by combining the two parts
as shown in the picture (3).
9 Tighten the buckles by pulling the adjustment
strap towards you, making sure they fit well
against your child's body at every point and that
the clip is at the height of the sternum.
CAUTION: Do not over-tighten the straps, and
ensure you leave minimum slack.
10 When you have completed the operation, check
the tension of the belts in every point (1-2-3-4-5).
Check the shoulder pads fit well over the body.
11 To slacken the harness, insert a finger through the seat
opening (1), keep the metal button pressed, and with
the other hand pull on the straps (2).
12 IMPORTANT! In the winter, do not dress your
child in bulky clothing before strapping him/her into
the car seat. Do not position blankets between your
child' s body and the safety belts. This could cause
incorrect positioning of the safety harness, with
serious consequences in the event of a collision.
Use a blanket or an approved Peg-Pérego
accessory to protect your child from the weather.
13 The cup holder can be attached on either side, as
shown in the picture.
14 To guarantee greater safety, the car seat is equipped
with Kinetic Pods. Open the Kinetic Pod on the side
near the car door (fig_a). To close it, pull the Kinetic
Pod and fold it down into the specific hollow (fig_b).
15 This car seat has a booster cushion for smaller
children. Do not use it for children who are taller
than 87 cm.
To remove the booster cushion, unfasten and widen
the safety belts and slide the crotch strap through it
without removing the central buckle.
Removing the soft cover
16 To remove the headrest's cover, pull out the belts
at the side of the headrest and remove the cover as
shown in the picture.
17 Open the shoulder pads and separate them from
the belts.
18 Rotate the buckle that blocks the shoulder pads
onto the back rest following the procedure (fig_a)
and pull it through the eyelet (fig_b).
19 To remove the seat's cover, undo the 4 buttons on
the back rest.
20 Lastly, pull out the cover of the central knob from
the side of the seat (fig_a) and extract from above,
as shown in (fig_b).
TAKE CARE YOU DO NOT DAMAGE THE
POLYSTYRENE (EPS) ELEMENTS WHILE REMOVING/
REPLACING THE COVERS
22