Nedo TUBUS 1 Manual De Instrucciones página 17

Align Function
TUBUS1 has a convenient align function which can be used to line up the laser beam above the
pipe with a target mark. After completing the align function the laser returns to the previously set
tilt!
It is important to ensure that the allowable transverse axis tilt is not exceeded during the
active align function (warning in the display). Failure to ensure this can result in errors!
Change rechargeable battery pack
The rechargeable battery pack can be easily changed if necessary:
Undo the screw on the underside of the battery
compartment
TUBUS 1 Pipe Laser Operating Instructions
Press this button to start
the Align Function: the
laser beam is titled
upwards, up to the limit
position. Align mode is
signalled by fast flashing
of the laser beam.
The upwards movement
can be stopped at any
time by pressing the +/ –
buttons on the laser.
Renewed pressing of the
+/- buttons allows fine
alignment with a target
above the pipe.
transverse adjustment (left
To end the align function,
press the Align Function
transverse adjustment set
Carefully remove the rechargeable battery pack from
the laser
EN
The Arrow buttons can
be used to make the
/ right) of the laser beam
(lateral alignment with a
target).
button again. TUBUS1
returns to the previously
set tile and retains the
in the previous step.
17