Arregui PREMIER Manual De Instrucciones página 4

<EN>
Thank you for purchasing this PREMIER safe. We advise
you to read the instructions before you install and use
the safe to prevent its improper use from making the
guarantee void.
A. CHARACTERISTICS OF THE PRODUCT
FRONT DIAGRAM OF THE SAFE
1. KNOB.
2. PLASTIC COVER – EMERGENCY LOCK.
3. NUMERIC KEYPAD.
1
B. OPENING AND CLOSING THE SAFE
B.1. FIRST TIME THE SAFE IS OPENED AND
INSTALLATION OF THE BATTERIES
• Remove the small plastic cover on the front panel.
• Insert the key into the key hole and turn it counter-
clockwise direction
• Turn the doorknob clockwise direction to open the
safe.
• In order to function, the safe needs 4 x 1.5 V alkaline
batteries that are placed at the back of the door.
• Open the cover of the battery holder and place the
batteries taking into consideration their polarity.
• On completion of this process the electronic system
will be activated.
B.2. PROGRAMMING OPENING CODES
- Press the red button on the back of the door near the
hinge, release it and you will hear two beeps.
- Now press from 3 to 8 numbers that you wish to use
as a combination, and confirm by pressing the letter
. 2 beeps will indicate the personal code has been
accepted and stored. With the door opened, check if the
new code works correctly.
B.3. NORMAL OPENING
To open the safe, enter your personal code followed by
the letter . A green light will be on. Turn the doork-
nob clockwise to open the door. If the entered code is
incorrect, 3 short deep sounding beeps will sound. If
the incorrect code is used 3 times consecutively, you
must wait for 20 seconds before reattempting.
2
B.4. CLOSING
To close the safe, push the door and turn the knob
counterclockwise.
C. EMERGENCY OPENING
If you forget the code for opening, the safe can be
opened using the emergency key.
• Remove the small plastic cover on the front panel.
• Insert the key into the key hole and turn it counter-
clockwise direction
• Turn the doorknob clockwise direction to open the safe.
• Once the safe is open, press the reset button on the
3
back of the door with a non sharp object.
• Change the code for opening (see point B.2)
CAUTION
Do not keep the keys in the safe itself.
D. LOW BATTERY INDICATOR
Each time that you use the safe, the electronic system
verifies the condition of the batteries.
If the batteries are low, the red light (in the middle of
the number panel) will warn you immediately. The
safe needs 4 x 1.5 V alkaline batteries that are placed
at the back of the door. Open the cover of the battery
holder and place the batteries taking into consideration
their polarity. Once you have changed them, you must
reprogram the opening codes, (see point B.2).
E. INSTALLING THE SAFE
To reduce the risk of theft of the safe, it can be secured
to floor, wall or in a cupboard. For your convenience,
there are holes (diameter 8mm) on the back and in the
bottom; therefore it can be fixed by the expansion bolts.
CAUTION: The safe should be placed horizontally when
installing the safe.