Samsung NX58 Serie Manual Del Usuario página 32

Maintenance
To perform the self-cleaning cycle
Make sure the door lock is released. Remove all racks from the oven cavity.
2
1. Make sure the oven door is closed completely and unlocked.
2. Press the Self Clean pad once. Then, select the cleaning time by pressing the
Self Clean pad one or more times in accordance with the table below.
Once
3-hour cycle
3. Press the START/SET pad. The oven door is locked and the oven begins to heat
up.
4. When the self-cleaning cycle is complete, the oven beeps 10 times. The door
will remain locked and the Lock icon will blink until the oven temperature falls
below 400 °F (205 °C).
5. When the Lock icon changes to an open lock, you can open the oven door. The
Lock icon changes to an open lock when the oven temperature drops below
400 °F (205 °C).
6. Press the OVEN OFF pad to display the time of day.
CAUTION
Do not use the surface burners while the gas oven is performing a self-cleaning
cycle.
WARNING
Be sure all controls are OFF and all surfaces are COOL before cleaning any part of
the range.
32 English
NX58R9311SS_AA_DG68-00905B-00_EN+MES+CFR.indb 32
Twice Three times
5-hour cycle 2-hour cycle
3
6
To delay the start of a self-cleaning cycle
1. Repeat steps 1 and 2 from the column on the left.
2. Press the Delay Start pad. The oven door locks.
3. Set the time you want the oven to start self-cleaning using the number pad.
4. Press the START/SET pad. The oven will start self-cleaning at your specified
time.
To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke
in the oven. To turn off the self-cleaning cycle, press the OVEN OFF pad. The cycle
turns off, but the door remains locked and the Lock icon blinks until the oven
temperature falls below 400 °F (205 °C).
NOTE
Make sure all surface burners are off before
running a self cleaning cycle. Self-clean will
not operate if a surface burner is on.
3
4
2
2019-05-30 6:11:14