MZ electronic EV030-Radio Instrucciones De Uso página 19

Warning
ALWAYS DISCONNECT THE BATTERY PRIOR TO INSTALLATION.
•
The chain counter must be positioned so that the display will be easy to read. It should not be
exposed to direct sunlight.
•
The rear part of the instrument must be protected from contact with water or moisture.
•
The instrument may be fastened to dashboards of any thickness. The screws used for clamping
must be of the self-threaded kind and with a diameter of 3.5 mm (~9/64") and a maximum
length of 10 mm plus the thickness of the dashboard.
•
In the part to the rear of the dashboard there must be minimum clearance of 35 mm (1" 3/8) and
there must also be adequate access to perform installation and maintenance work.
•
Apply the hole template on the dashboard (see appendix) and make a hole with a diameter of
30 mm (~ 1" 3/16) in the centre, as indicated, and 4 holes with diameters of 4 mm (~5/32") for
the chain counter clamping screws. Use cutting nippers to cut the three pins on the back of the
instrument, position the chain counter and fasten it to the dashboard by tightening the four
screws. If the dashboard already has a hole with a 54 mm (2"1/8) diameter, it is not necessary
to cut the pins on the back.
•
The seal must be positioned between the chain counter and the dashboard.
EV030-Radio 19
English
Rev. 08 – 2019