Adjusting The Looper Thread Cam Thread Guide And The Looper Thread Cam; Adjusting The Looper Thread Winding Prevention Plate - JUKI MF-7200D Manual De Instrucciones

6. Adjusting the looper thread cam thread guide and the looper thread cam
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the fol-
lowing work after turning the power off and ascertaining that the motor is at rest.
Thread
2
A
B
6
7. Adjusting the looper thread winding prevention plate
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the fol-
lowing work after turning the power off and ascertaining that the motor is at rest.
3
4
1
A
B
5
7
1
A
2
[Adjusting the looper thread cam]
Adjust so that thread comes off from the hghest place
of looper thread cam 2 when needles come down
and the top end of left needle 3 algns wth the bottom
surface of looper 4 . Then tghten screws 1 to fix the
looper thread cam.
[Adjusting the looper thread cam thread guide]
When the thread drawng amount s desred to be de-
creased n case of 2-needle machne or the lke, loosen
screws 7 , move upward thread gudes 5 and 6 and
tghten screws 7 to fix them.
A = Decrease B = Increase
Adjust so that a clearance of approxmately 0 to 0.3
mm s provded between the top end of secton A of
looper thread wndng preventon plate 1 and the end
face of looper thread cam 2 .
– 16 –