General Installation Requirements - Sinmag Europe MANO Manual Del Usuario

ENG
2.2 Working safety information
The machine must only be used by personnel suitably trained for the purpose and who
have been trained in the contents of this publication.
To ensure safety, comply with the following instructions:
1.
Install the machine in compliance with workplace safe work requirements.
2.
Don't place the machine near a source of heat and this machine must not be used in
a place where the surrounding environment may have a potential risk of explosion.
3.
Use the machine with great care and never be distracted.
4.
Do not wear loose fitting clothing or clothing with wide or open sleeves.
5. Do not remove, cover or modify the identification plates placed on the machine
body.
6. Do not use the machine as a working surface or area and do not place any objects
on it that are not required for normal working operations.
7. Do not use machine with temporary electrical connections or non-insulated cables.
8.
Periodically check the state of the power cable and the cable clamp on the machine
body, have it replaced by qualified personnel as soon as is necessary.
9.
Stop the machine immediately as soon as there is any defective or abnormal opera-
tion, a breakage, any incorrect movements, or unusual noises.
10.
Before cleaning or carrying out maintenance, disconnect the machine from the
electricity mains.
11. Use protective working gloves for cleaning and maintenance.
12.
For all extraordinary maintenance, consult the manufacturer or qualified and
authorised personnel.
13.
Do not use water jets or spray to clean the machine.
14. When sharp accessories are manipulated, use cut-resistant gloves.
3. INSTALLATION

3.1 General installation requirements

NOTE:
It is most important that this machine is installed correctly and that the
operation is correct before use. Installation shall comply with local electrical,
fire, health and safety requirements.
This slicer is designed to provide years of satisfactory service. Correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
3.2 Installation
This appliance is to be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room.
Installations must be carried out by qualified service persons only. Failure to install
equipment according to relevant codes and manufacturers specifications in this section
will void the warranty.
Components having adjustments protected (e.g. paint sealed) by manufacturer are
only to be adjusted by an authorised service agent. They are not to be adjusted by the
installation person.
It is the responsibility of the owner to supply and arrange for the connection of all ser-
vices to the machine.
4
SINMAG EUROPE BVBA