Micro Matic smartDRAFT Instrucciones De Funcionamiento página 9

Trouble shooting for bar staff
Problem Reason
No beer flow, when Tap not connected correctly
dispense handle is
One-way beer line has been used once
pulled
One-way beer line is defective
Tap is defective
Beer is too warm
No beer in the keg
No CO
Beer is foaming Handle is not opened completely
Handle is opened/closed too slowly
Glass is too warm
Beer is too warm
One-way beer line is defective
Too less foam Beer glass is not clean
No CO
Beer too cold
Beer is too warm Keg is not prechilled
Cooler is/was not connected to
electricity
Cooler is not adjusted correctly
Cooler is defective
Beer is too cold Temperature of prechilled keg too low
Cooler is not adjusted correctly
CO is leaking Tap not connected correctly
2
No one-way beer line installed
One-way beer line is defective
Tap is defective
Keg is defective
Beer is leaking One-way beer line is defective
Gasket in keg defective
Only gas is coming Keg is empty
out, when handle is
One-way beer line has already been
pulled
used once
in the keg
2
in the keg
2
Solution
Open and close tap cover again
Replace one-way beer line
Replace one-way beer line
Contact brewery
See problem „beer is too warm" below
Replace keg
Replace keg and contact brewery
Open handle completely
Open/close handle fast in one move
Cool glass with cold water before
dispensing
See problem „beer is too warm" below
Replace one-way beer line
Clean glass with beer glass cleaner
Replace keg and contact brewery
See problem „beer is too cold" below
Take prechilled keg
Cool down keg in cooler (~ 3 hours)
Keep cooler connected when a keg is
connected
Contact brewery
Contact brewery
Check temperature prechiller
Contact brewery
Open and close tap cover again
Install one-way beer line
Replace one-way beer line
Contact brewery
Replace keg and contact brewery
Replace one-way beer line
Replace keg and contact brewery
Replace new keg
Install new one-way beer line
8