Dexter 20VMT2-20.1 Manual De Instrucciones página 304

FR FR
2. SAFETY INSTRUCTIONS
ES ES
used. Use of dust collection can reduce dust-related hazards.
PT PT
H.Do not let familiarity gained from frequent use of tools allow you
to become complacent and ignore tool safety principles. A careless
IT IT
action can cause severe injury within a fraction of a second.
EL EL
POWER TOOL USE AND CARE
A. Do not force the power tool. Use the correct power tool for your
PL PL
application. The correct power tool will do the job better and safer at the
rate for which it was designed.
RU RU
B. Do not use the power tool if the switch does not turn it on and off.
Any power tool that cannot be controlled with the switch is dangerous and
KZ UA
must be repaired.
C. Disconnect the plug from the power source and/or the battery
KZ UA
pack from the power tool before making any adjustments,
changing accessories, or storing power tools. Such preventive safety
RO
RO
measures reduce the risk of starting the power tool accidentally.
D. Store idle power tools out of the reach of children and do not allow
BR
BR
persons unfamiliar with the power tool or these instructions to
operate the power tool. Power tools are dangerous in the hands of
EN
EN
untrained users.
E. Maintain power tools. Check for misalignment or binding of
moving parts, breakage of parts and any other condition that
may affect the power tools operation. If damaged, have the
power tool repaired before use. Many accidents are caused by poorly
maintained power tools.
F. Keep cutting tools sharp and clean. Properly maintained cutting tools
with sharp cutting edges are less likely to bind and are easier to control.
G. Use the power tool, accessories and tool bits etc. in accordance
with these instructions, taking into account the working
conditions and the work to be performed. Use of the power tool
for operations different from those intended could result in a hazardous
situation.
H.Keep handles and grasping surfaces dry, clean and free from oil
and grease. Slippery handles and grasping surfaces do not allow for safe
handling and control of the tool in unexpected situations.
304