Speed Dial - Dexter 20VMT2-20.1 Manual De Instrucciones

FR FR
5. OPERATION
ES ES
2. To switch off the machine, release the On/off switch.
PT PT
CONTINUOUS WORKING MODE
IT IT
1. Keep the On/off switch pressed.
2. Activate the switch lock for continuous working.
EL EL
3. To switch off the machine, deactivate the switch lock firstly, then release the On/off switch.
PL PL

SPEED DIAL

The orbital stroke rate can be preselected by turning of speed dial.
RU RU
You can also set the orbital stroke rate during operation by turning of the speed dial.
The required orbital stroke rate is dependent on the material and the work conditions and can be
KZ UA
determined using practical tests.
Orbital stroke rate level "6" is recommended for sawing, cutting and sanding harder materials, such
as wood or metal; orbital stroke rate level "4" is recommended for softer materials, such as plastic.
KZ UA
SANDING
RO
RO
The material removal rate and sanding result are primarily determined by the choice of sanding
paper, the preselected orbital stroke rate level and the contact pressure. Only immaculate sanding
BR
BR
sheets achieve good sanding performance.
1. Ensure the workpiece is free of obstacles like nails or screws before operation. Remove them if
EN
EN
required. Where possible, secure smaller workpieces to prevent them from moving under the
product.
2. Hold the product with one hand on the main handle and with the other hand on the auxiliary
handle.
3. Switch the product on and wait until it runs at full speed before placing it on the workpiece.
4. Move the product slowly and steadily over the workpiece surface in parallel and overlapping
strokes.
5. Only apply the least possible pressure to keep the product flat on the workpiece. Higher pressure
will not increase but lower the performance of the product, increase wear of the sanding paper
and leads to uneven results.
6. Work with dust extraction system particularly when sanding coats of varnish as the varnish
could melt and smear the surface of the workpiece and the sanding paper.
7. Keep the product moving at all times, do not stop in one position to avoid grooves.
8. Lift the product from the workpiece before switching it off.
314