Maintenance And Cleaning - Newteck Secadry XLL Manual De Instrucciones

· Programme drying time: you can programme up to 180 minutes, adjust the
desired time using the control wheel. The device will turn off automatically
once the programmed time has been reached.
· Continuous drying: position the control wheel in the "ON" option, the device
will remain turned on until you stop it. The device should not continuously
run for more than 360 minutes. If this time has passed and you need to
activate it again, leave a break of 30 minutes between each cycle.
Do not touch or cover the air vent when the device is running.
The air vent on the device and the air vent on the outer cover must be properly aligned,
ensuring that the position is correct before activating the device to avoid air escaping
and optimising performance.

MAINTENANCE AND CLEANING

1. Turn off and unplug the device from the electrical current. Wait until the
device becomes cold before starting cleaning.
2. Clean the whole surface and parts with a soft cloth, if necessary you can
lightly dampen it with water and soap. The surface must be cleaned to avoid
discolouration and damage.
3. If you are not going to use the device for a long period of time, keep it clean
in a dry place with no humidity.
Do not submerge the device or its parts in water.
Do not use solvents, bleach or corrosive substances to clean the device.
18
Air vent
Time scale (timer)
ON: Continuous drying mode
OFF: Stop
Control wheel