Opening The Door In Case Of Power Failure; Printer / Usb Setup - SciCan HYDRIM C51wd Manual Del Operador

5. Instructions for Use

5.11 Printer / USB Setup

The Hydrim C51wd has an RS-232 port at the back, and can be used with an external
printer or the SciCan Data Logger. The printers in the chart below have been tested with
the Hydrim. To add or change a printer or SciCan Data Logger, follow these steps:
Turn off the Hydrim and the printer or Data Logger before connecting these devices to the
unit.
1.
With the printer or Data Logger connected, turn on the Hydrim and press the i to move
to the Menu screen.
2.
In the Setup Menu, select Printer Selection.
3.
Select Serial Printer if connecting a
printer, or USB Flash/MSD if
connecting the SciCan Data Logger.
Press the back arrow to return to the
Setup Menu.
4.
In the Setup Menu, select Baud rate.
5.
Select the rate required (refer to chart
below for recommended Baud rates).
Use the back arrow to return to the
Start screen.
6.
Ensure that the date and time have
been set (see Setup Menu – Date /
Time)
7.
Now the Hydrim will write its cycle
information to the device chosen.
Page 19

5.10 Opening the Door in Case of Power Failure

If there is a power failure, open the detergent door and remove
the chemical bottle. Keep the chemical bottle upright and ensure
that the chemical does not spill. Locate the ring in the top of the
detergent compartment and pull it to open the door. Exercise
caution! There may be fluid remaining in the unit and the
instruments may be hot. Instruments that have not completed
the cycle should not be used and should be reprocessed.
Printer Model
Epson
TM-U220D (C31C515603)
Citizen
IDP-3110-40 RF 230B
Star Micro
SP212FD42-230
Star Micro
SP216FD41-230
Star Micro
SP512MD42-R
SciCan Data Logger
For Mass Storage Device
HYDR IM C51wd Operator's Manual
Serial Port
Baud Rate
9600
9600
9600
9600
9600
Serial Port
Baud Rate
9600