Introduction; General Information - Zeiss Stemi 305 cam Instrucciones De Manejo

ZEISS
1

INTRODUCTION

1.1

General information

The stereo microscope Stemi 305 cam has been designed, produced and tested in compliance with the
standards DIN EN 61010-1 (IEC 61010-1) and IEC 61010-2-101 "Safety Requirements for Electrical
Measuring, Control and Laboratory Equipment".
The power unit used corresponds to DIN EN 60950-1 (IEC 60950-1) "Information technology
equipment - Safety".
This device complies with the requirements of the EC Directive 98/79/EC Annex 1 regarding ivd products,
EC RoHS Directive 2011/65/EU (RoHS) and EC Directive 1999/5/EC (R&TTE, Radio Equipment &
Telecommunications Terminal Equipment) and bears the
This operating manual contains information and warnings to be observed by the operator.
The devices must be disposed of in compliance with the WEEE Directive 2012/19/EU.
The Stemi 305 cam body with Wi-Fi may only be used if it is covered by a radio license for your region. At
present (state 06/2016) Stemi 305 cam bears a radio license for the following regions: USA, Canada,
European Economic Area (EEA) and Switzerland, Japan, China, Australia, New Zealand, Colombia. In
doubt, please contact your regional ZEISS representative.
The warning and information symbols explained below are used in these operating instructions:
CAUTION
This symbol identifies a risk for the user.
ATTENTION
This symbol identifies a risk for the device or system.
NOTICE
This symbol identifies a note which must be given special attention.
2
INTRODUCTION
General information
- mark.
435063-9144-008
Stereo microscope
Stemi 305 cam
06/2016