Start-Up - LIVARNO LUX 14129204L Instrucciones De Montaje

Now use the slots in the mounting bracket
screws to mark the drill holes (Ø 6 mm, depth approx. 40 mm).
14
Ensure that you can connect the spotlight
tion cable
15
Now drill the fixing holes. Before drilling the fixing holes, ensure
there are no gas, water or electrical lines that could be drilled
into or damaged in the area where you will be drilling.
Insert the dowels
Attach the mounting bracket
Place the solar panel
Ensure that the solar panel
Insert the plug
Set the ON / OFF slider
position (Fig. A).
The rechargeable batteries will now charge when there is suffi-
cient solar radiation.
Your light is now ready to use.

Start-up

The motion detector is activated at an illumination level of approx.
<100 Lux.
The spotlight
soon as the sensor
The light will automatically switch off after approx. 30 seconds
if motion is no longer detected.
If any motion is detected after it has been switched off, the light
will automatically switch on again for approx. 30 seconds.
to the solar panel
into the drill holes (Fig. C).
13
12
into the mounting bracket
1
1
into the socket
16
on the spotlight
2
will automatically switch on in darkness as
3
detects motion.
4
intended for the
12
using the connec-
3
.
1
using the screws
is orientated towards the sun.
(Fig. D).
17
3
.
14
(Fig. C).
12
to the „ON"
GB/IE 35