Electrical Connection - Beem DYNAMIC i-POWER Manual De Instrucciones

EN
CAUTION
► Do not use sharp objects or abra-
sive cleaning agents to clean the
surfaces.
► Never lift or move the appliance with
the mains cable.
► Only pour water into the tank and no
other fluids or additives.
► Pay attention to the "MAX" mark. Do
not overfill!
Requirements for the place of use
For safe and trouble-free operation of the
appliance, the place of operation must sat-
isfy the following requirements:
■ Use the appliance on an even, stable,
heat-resistant and splash-proof surface
(ironing board).
■ Do not use the appliance in a hot, wet
or very humid environment or in the
vicinity of inflammable materials.
■ Immediately after ironing, place the hot
appliance at least 15 cm away from
walls, furniture and other objects.
■ Select a location that does not allow
children to reach the hot surfaces, the
appliance itself or the connecting cable
of the appliance.
■ The mains socket must be easily ac-
cessible and allow fast disconnection
in the event of an emergency.
BEEM - Elements of Lifestyle
DYNAMIC i-POWER

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions must
be observed for the electrical connection:
■ Before connecting the appliance,
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. The
data must correspond in order to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
■ The mains socket must be protected
by at least a 16 A fuse.
■ Ensure that the mains cable is undam-
aged and is not laid over hot surfaces
or sharp edges.
■ The mains cable must not be pulled
tightly, bent or come into contact with
the hot appliance.
■ Route the cable to prevent risk of trip-
ping.
■ The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.
19