Operation And Use; Dry Ironing - Beem DYNAMIC i-POWER Manual De Instrucciones

DYNAMIC i-POWER
– When you let go of the handle (6),
the appliance switches itself off (au-
tomatic safety switch-off, fig. B) and
the control indicator (11) flashes.
– To reactivate the appliance, you
must grip the handle (6) again and it
will switch itself on.
■ The anti-drip system prevents water
from dripping out of the ironing sole at
low temperatures.
■ The appliance slides smoothly over the
fabric due to the ceramic coating of
the ironing sole (16).
■ The anti-liming system of the appli-
ance removes calcification from the
water if you use tap water for steam
ironing instead of distilled water (Fill-
ing with water section).
■ The self-cleaning function removes
calcium residues from the appliance,
see Cleaning and care section.
22

Operation and use

Dry ironing

Turn the steam flow regulator (3) to
‹
position 0.
During heating up, make sure that
‹
the appliance is placed upright on an
even surface.
Insert the plug of the appliance into
‹
the mains socket. The control indica-
tor (11) light up.
Set the desired temperature with the
‹
temperatur regulator (13).
The temperature indicators (9) light up
on both sides of the appliance during
heat-up.
Wait until the appliance has heated
‹
up, the control indicator (11) flashes
and the temperature indicators extin-
guish.
Fill with water
NOTE
► Only fill the the tank of the appliance
with tap water up to 17° dt. hard-
ness (3 mmol/l). If your tap water is
harder, use a mixture that consists of
equal parts of tap water and distilled
water.
► The lifecycle of the appliance is pro-
longed if pure distilled water is used.
Set the temperature regulator (13) to
‹
the "OFF" position and pull the plug
out of the mains socket.
Open the tank lid (2) (fig. C).
‹
Put the appliance with the ironing
‹
sole onto an even surface and incline
it back so that it stands on the rear
housing edge.
BEEM - Elements of Lifestyle
EN