Cleaning And Care; Storage; Self-Cleaning Function - Beem DYNAMIC i-POWER Manual De Instrucciones

EN

Storage

If you do not intend to use the appliance
for a longer period of time, clean it as de-
scribed in the Cleaning and care section.
Allow the appliance to cool down com-
pletely before storing.
Store the appliance in an upright position,
not on the ironing sole.
Store the appliance and all accessory
parts at a dry, clean and frost-free loca-
tion, which is protected against direct
sunlight.

Cleaning and care

Before beginning work, pay attention to
the safety instructions in the section on
safety!
Ironing sole
■ Clean the ironing sole with a soft damp
cloth. Subsequently wipe with a soft
dry cloth.

Self-cleaning function

Self-cleaning function
Regularly perform (at least after every
10 hours of use) the following work steps
described.
Turn the steam flow regulator (3) to
‹
position 0.
Set the temperature regulator (13) to
‹
the "OFF" position.
Pull the plug out of the mains socket.
‹
BEEM - Elements of Lifestyle
DYNAMIC i-POWER
Fill the water tank (12) up to about
‹
a half with water as described in the
Filling with water section. It is rec-
ommended only to use distilled water
for self-cleaning.
Insert the plug of the appliance into
‹
the mains socket. The control indica-
tor (11) light ups.
Turn the temperature regulator (13) to
‹
the "MAX" position.
The temperature indicators (9) light up
on both sides of the appliance during
heat-up.
Wait until the appliance has heated
‹
up, the control indicator (11) flashes
and the temperature indicators extin-
guish.
Set the temperature regulator (13) to
‹
the "OFF" position.
Pull the plug out of the mains socket.
‹
Hold the appliance horizontally over a
‹
wash basin or similar.
Press the self-clean button (15).
‹
Allow the the water tank to empty
‹
completely. Lightly tilt the appliance
back and forth so that the water can
run out of all nozzles.
Repeat the cleaning procedure as
‹
often as necessary until no calcium
deposits come out of the nozzles.
If necessary, briefly switch on the ap-
‹
pliance to allow residual amounts of
water to evaporate.
NOTE
► It is not necessary to decalcify the
appliance separately.
25