Peg-Perego primo viaggio tri-fix ISIP Instrucciones De Uso página 15

observe him/her even when sleeping.
• Never remove the child from the seat while the vehicle is in
motion.
• Make sure that the safety seat is protected from any mobile
parts of the car seat or doors.
• To avoid the risk of falling always use the safety seat
harness even for transport outside the vehicle. Adjust the
height and tension of the straps ensuring that they are
snug to the child's body without constricting him/her too
much. Check that the harness is not twisted and that the
child does not release it.
• This car safety seat is not designed for extended periods of
sleep. The safety seat is not a substitute for a cot and if the
child needs to sleep it is important to lie him/her down.
• Do not leave the car safety seat in the car exposed to the sun.
Some parts might heat up and be harmful to the delicate skin
of the child -check before placing the child in the seat.
• Do not use the safety seat without its fabric covering,
which cannot be replaced with one not approved by the
manufacturer since it is an integral part of the safety seat
and the safety system.
• If in doubt refer to the manufacturer or retailer of the safety
seat.
• Do not remove the adhesive and stitched labels since
this might make the product non compliant with legal
requirements.
• Do not use the safety seat if it has signs of breakage or
missing parts, is second hand, or if it has been subjected to
violent stress in an accident, because it might have suffered
extremely dangerous structural damage.
• Do not modify the product.
• For any repairs, replacement parts and information about
the product, contact the after-sales assistance service.
Contact information is provided on the last page of this
manual.
• Do not use this car safety seat after five years from the
date of production indicated on the structure. The natural
ageing of the materials may mean that it is no longer
compliant with standards.
• The use of the safety seat for premature infants born at less than
37 weeks could cause respiration problems for the infant seated
in the safety seat. It is advisable to seek medical advice before
leaving the hospital.
• Do not use accessories not approved by the manufacturer or by
the competent authorities.
• To avoid the risk of falling, never place the safety seat on raised
surfaces (tables, work surfaces) soft surfaces (beds, sofas) or
sloping surfaces.
• In the home do not use the car safety seat if the child is able to
remain seated alone.
Instructions for use
1• "Primo Viaggio Tri-Fix ISIP" is provided with the Ganciomatic
System for in-car attachment and detachment from an "Isofix
Base" or "Adjustable Base" and outside the vehicle to Peg-
Pérego strollers and chassis. To attach "Primo Viaggio Tri-Fix
ISIP" (to an "Isofix Base", "Adjustable Base", or Peg-Pérego stroller
or chassis) align it with the attachment points and push down
with both hands until it clicks into place.
2• To release "Primo Viaggio Tri-Fix ISIP" (from an "Isofix Base",
"Adjustable Base", or Peg-Pérego stroller or chassis) raise the
handle to the transport position, push the lever on the backrest
upwards and at the same time raise the safety seat.
3• To engage the safety harness, put the two shoulder straps on
and insert them into the buckle of the crotch strap until they
click into place.
4• To release the safety harness press the red button on the crotch
strap buckle.
5• To change the height of the harness: detach the belt at the
back (fig. a) and unthread the shoulder straps from the holes.
Reposition them from the front in the most appropriate hole for
the height of the child (fig. b).
6• To slacken the harness, insert a finger into the seat slot (fig. a),
press the metal button and at the same time pull the shoulder
straps upwards with the other hand (fig. b).
To tighten the harness on the child, pull the strap towards you
(fig. c), taking care not to over-tighten it and leaving a minimal
amount of play.
7• The seat has three holes for adjusting the height of the harness
for the height of the child. The harness should not be too high
or too low relative to the child's shoulders. The correct position
is with the child's shoulders just above the holes.
15