Makita GV7000 Manual De Instrucciones página 6

1
2
► 1. Cover 2. Side grip
CAUTION:
• Always be sure that the side grip is installed
securely before operation.
Install the cover, then screw the side grip on the tool
securely. The side grip and the cover can be installed
on either side of the tool.
Installing or removing abrasive disc
1
2
3
► 1. Lock nut 2. Abrasive disc 3. Rubber pad
4. Spindle
Mount the rubber pad onto the spindle. Fit the abrasive disc
on the rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, hold the spindle with the wrench
so that it cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
► 1. Lock nut wrench 2. Wrench
To remove the disc, follow the installation procedure in reverse.
4
1
2
OPERATION
Sanding operation
CAUTION:
• Always wear safety goggles or a face shield
during operation.
• Never run the tool without the abrasive disc. You
may seriously damage the pad.
Hold the tool firmly. Turn the tool on and then apply the
abrasive disc to the workpiece.
In general, keep the abrasive disc at an angle of about
15 degrees to the workpiece surface. Apply slight pres-
sure only. Excessive pressure will result in poor perfor-
mance and premature wear to abrasive disc.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
Replacing carbon brushes
► 1. Limit mark
6 ENGLISH
15
1