DeWalt D55151 Manual De Instrucciones página 22

CoDE possIBlE CAusE
4 Fuse blown, circuit breaker tripped
5 Tank pressure exceeds pressure switch cut-in pressure
6 Pressure release valve on pressure switch has not
unloaded head pressure
possIBlE solutIon
1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for your particular
branch circuit.
. Check for proper fuse. Use only a time delay fuse.
. Check for low voltage conditions and/or proper extension
cord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.
Motor will start automatically when tank pressure drops
below cut-in pressure of pressure switch.
Set the On/Off switch to OFF. If the valve does not open,
replace switch. Contact a D
a D WALT authorized service center.
e

WALT factory service center or
e