Troubleshooting - Selco Quasar 35 Instrucciones De Uso

6 TROUBLESHOOTING

The repair or replacement of any parts in the
system must be carried out only by qualified
personnel.
The repair or replacement of any parts in the system by unau-
thorised personnel will invalidate the product warranty.
The system must not be modified in any way.
The manufacturer disclaims any responsibility if the user
fails to follow these instructions.
The system fails to come on (green LED off)
Cause No mains voltage at the socket.
Solution Check and repair the electrical system as needed.
Use qualified personnel only.
Cause Faulty plug or cable.
Solution Replace the faulty component.
Contact the nearest service centre to have the sys-
tem repaired.
Cause Line fuse blown.
Solution Replace the faulty component.
Cause Faulty on/off switch.
Solution Replace the faulty component.
Contact the nearest service centre to have the sys-
tem repaired.
Cause Faulty electronics.
Solution Contact the nearest service centre to have the sys-
tem repaired.
No output power
Cause Faulty torch trigger button.
Solution Replace the faulty component.
Contact the nearest service centre to have the sys-
tem repaired.
Cause The system has overheated (temperature alarm -
yellow LED on).
Solution Wait for the system to cool down without switching
it off.
24
7.
Remove the cable clamp
and gusset (H).
8.
Pull out the torch from the
outside (I).
Cause Incorrect earth connection.
Solution Earth the system correctly.
Read the paragraph "Installation ".
Cause Mains voltage out of range (yellow LED on).
Solution Bring the mains voltage within the power source
admissible range.
Connect the system correctly.
Read the paragraph "Connections ".
Cause Faulty electronics.
Solution Contact the nearest service centre to have the sys-
tem repaired.
Incorrect output power
Cause Faulty potentiometer for the adjustment of the cut-
ting current.
Solution Replace the faulty component.
Contact the nearest service centre to have the sys-
tem repaired.
Cause Faulty electronics.
Solution Contact the nearest service centre to have the sys-
tem repaired.
No pilot arc striking
Cause Faulty torch trigger button.
Solution Replace the faulty component.
Contact the nearest service centre to have the sys-
tem repaired.
Cause Worn nozzle and/or electrode.
Solution Replace the faulty component.
Cause Air pressure too high.
Solution Adjust the air flow.
Read the paragraph "Installation".
Cause Faulty electronics.
Solution Contact the nearest service centre to have the sys-
tem repaired.
No cutting arc striking
Cause Incorrect earth connection.
Solution Earth the system correctly
Read the paragraph "Installation".
Cutting arc extinction
Cause Mains voltage out of range.
Solution Connect the system correctly.
Read the paragraph "Connections".
Cause Insufficient air flow rate.
Solution Adjust the air flow.
Cause Damaged pressure switch.
Solution Replace the faulty component.
Cause Air pressure too high.
Solution Adjust the air flow.
Read the paragraph "Installation".
Cause Incorrect cutting mode.
Solution Decrease the cutting travel speed.
Cause Worn nozzle and/or electrode.
Solution Replace the faulty component.