INDOOR AMPLIFIED ANTENNA
The Meliconi AT 38 PLUS indoor amplifi ed antenna can receive and amplify digital terrestrial
TV signals and DAB radio signals on VHF bands (band 3rd- 174~230 MHz) and UHF bands
(470~790 MHz).
The antenna can be connected to a television or a digital terrestrial decoder.
A
• The product is for internal use only; do not use outdoors.
• Keep away from water: the appliance must not be exposed to dripping or splashing water. Do not
use in damp surroundings.
• The product must not be exposed to sources of excessive heat, such as solar radiation, fi re or similar.
• Do not use a power supply other than the one provided with the appliance.
• The AC adaptor must be readily accessible so that the device can be easily disconnected from the
power supply.
• If you notice any faults in the AC adapter, disconnect it immediately from the socket.
• To avoid electric shock, do not tamper with the appliance or attempt to repair it.
• The product is not a toy; it must not be left within reach of children or pets.
• Before setting up the connections, disconnect the appliances from the power supply.
B
• Place the antenna in a favourable position, for example near a window and/or toward a tv
transmission tower away from metal objects, electrical appliances and reinforced concrete walls
that would restrict its functioning.
• Connect the Meliconi antenna cable to the antenna socket at the back of the television or digital
terrestrial decoder (fi gure 1). If the decoder antenna socket is F-female type, obtain a F-male/IEC-
female adapter (not included in the box).
• Use the AC/DC power supply included in the box to power the antenna; insert the cable into the
antenna power input and connect the power supply to a 230V~/50Hz socket (fi gure 2).
• For use on a boat or in a camper van, the antenna can be powered via the DC 12V 100mA input
(fi gure 2), respecting the polarities indicated on the power socket. (adapter not supplied)
• Rotate the knob (fi gure 3) to turn on the antenna and position it at maximum amplifi cation.
• LED on, indicates that connection to the power supply is correct.
• Switch on the device (TV/DECODER) and select the desired channel.
AT38 PLUS
INSTRUCTIONS FOR USE
Thank you for choosing MELICONI.
Safety warnings
Installation
EN
3