Table Of Basic Menu Parameters; Description Of Basic Menu Parameters - ICAR RPA Instrucciones De Uso

1.7 TABLE OF BASIC MENU PARAMETERS

PARAMETER 1
P.01
Smallest step kvar (lowest common multiple)
P.02
P.03
P.04
P.05
P.06 (LED 1)
P.06 (LED 2)
Penultimate step coefficent.
Follow the same programming for the re-
P.06 (LED n-1)
maining steps as above for the first two
steps except for the last two.
Last step coefficient.
Follow the same programming for the re-
P.06 (LED n)
maining steps as above for the first two
steps except for the last two.
Setting of required cosφ value (Ind).
CAUTION! If you have purchased a finished panel, this is the only parameter to be
preset.
n = Number of controller steps.
noA = Normally open contact under no alarm conditions.
ncA = Normally closed contact under no alarm conditions.
FAn = Fan control.
See Measurement and cosφ setting section on page 37.

1.8 DESCRIPTION OF BASIC MENU PARAMETERS

P.01 - CT primary current
CT primary current.
view and change the
previous
parameter
DESCRIPTION
CT primary current
Rated capacitor voltage (V)
Reconnection time (sec)
RPA - Sensitivity (sec)
RPE - Sensitivity
Step 1 coefficient
Step 2 coefficient
34
parameter
subsequent
OFF... 10.000
parameter
RANGE DEFAULT
OFF
0.10... 300 1.00
80... 750V 400
5... 240sec 60
5... 600sec 60
1... 8
0... 16
0... 16
0... 16
noA
ncA
FAn
0... 16
noA
ncA
FAn
0.80Ind...
0.95Ind
0.80Cap
1
0
0
0
0