ICAR RPA Instrucciones De Uso página 52

P.49 - Harmonic event delay
Harmonic event generation delay time applied to the threshold defined by the previous
parameter.
P.50 - RS-232 port protocol
Selects the protocol used on the RS-232 serial port.
Possible selections: the Modbus
protocol, used for applications that use modems.
When using a modem without auto-answer, the A.Ans setting allows to use the
®
Modbus ASCII protocol and to answer to an incoming call.
P.51 - RS-232 serial communication address
Defines the serial address of the controller, used by the Modbus
P.52 - RS-232 serial port speed
Selects serial communication speed (baudrate) of the RS-232 serial port.
P.53 - RS-232 serial port parity
Selects the parity used in serial communication on the RS-232 port.
Possible settings: None, Odd or Even
P.54 - RS-232 word length
Selects the length of the word (8 bits or 7bits) used in RS-232 serial communication.
Note: This parameter can be set to 7 bits only when the Modbus
protocol has been selected.
P.55 - RS-485 port protocol
Selects the protocol used on the RS-485 serial port.
Possible selections: the Modbus
protocol, used for applications that use modems.
P.56 - RS-485 serial communication address
Defines the serial address of the controller, used by the Modbus
P.57 - RS-485 serial port speed
Selects serial communication speed (baudrate) of the RS-485 serial port.
P.58 - RS-485 serial port parity
Selects the parity used in serial communication on the RS-485 port.
Possible settings: None, Odd or Even.
P.59 - RS-485 word length
Selects the length of the word (8 bits or 7bits) used in RS-485 serial communication.
Note:This parameter can be set to 7 bits only when the Modbus
protocol has been selected.
®
RTU (standard) protocol and the Modbus
®
RTU (standard) protocol and the Modbus
47
®
communication protocol.
®
ASCII communication
®
communication protocol.
®
ASCII communication
®
ASCII
®
ASCII