Air Supply - Napa 6-1039 Manual De Instrucciones

AIR SUPPLY

Whip Hose
Do Not In stall
Quick Coupling Nipple
Here
Leader
Hose
Tools of this class operate on
a wide range of air pres s ures.
We recommend that air
pressure mea s ures 90 PSI at
the air inlet while in use. Low
pressure (less than 90 psig 6.2
bar) re d uc e s the speed and
performance of all air tools.
High pres s ure (over 115 psig 8.0
bar) exceeds the rated capacity
of the tool, which will short e n
tool life through faster wear
and could cause injury.
Always use clean, dry air.
Dust, corrosive fumes, and/or
water in the air line will cause
damage to the tool. Drain the
air tank daily. Clean the air inlet
filter screen at least per week.
LUBRICATION
Lubricate the air motor daily
with NAPA air tool oil. If no
air line oiler is used, run 1/2 oz.
of oil through the tool. Apply a
OPERATION
When using the metal blaster
tool, be careful not to exert
excessive force. Too much force
could be hazardous if it causes
the spindle to bend or break.
Excessive speed reduction
indicates too much force being
applied to the work surface.
please revieW all Warning insTrucTions prior To operaTion. save This Man u al for fuTure ref er ence.
6-1039
Nipple
Quick Coupler Oiler
The air inlet used for
con n ect i ng air supply, has
stan d ard 1/4" NPT American
Thread. Line pressure should
be increased to compensate
for unusually long air hoses
(over 25 feet). Minimum hose
diameter should be 3/8" I.D.
Fittings should have the same
inside dimensions and should
be tightly secured.
few drops into the tool air inlet
or into the hose at the nearest
con n ec t ion to the air supply,
then run the tool. Overfilling
Apply moderate hand pressure
to the tool and allow the tools
accessories to do the work.
Avoid hazardous conditions by
making sure the spindle screw
is tightly secured in the spindle.
Air Supply
Filter
Regulator
Drain Daily
Spindle
Screw
S
pecificationS
Max. Free Speed . ......... 4,000 RPM
Spindle Thread ............... 3/8" - 24
Air Inlet . ......................... 1/4" NPT
Min. Hose Size . ............... 3/8" I.D.
Avg. Air Cons. . ................ 3.5 CFM
Recom. Air
Pressure . ............. 90 PSIG (6.2 bar)
Weight ............................... 2.7 lbs.
Length . ..................................11.2"
Sound Level .......................86 dBA
Wire Belt Width ................. 23mm
Wire Diameter (+ -)
...........................0.70 + - 0.015mm
Wire Material ..............Alloy Steel
Guard
Adjustable
Handle
Throttle
will cause a re d uc t ion in the
power of the tool.
Speed
Regulator
Air Inlet
3 3