Starting And Stopping The Cooking Cycle; Resetting The Appliance - Blanco BC GF 3500 Manual De Uso

STARTING AND STOPPING THE COOKING CYCLE

Important
The appliance automatically carries out a
preheating stage.
Starting
To carry out this operation, proceed as follows.
1 - Switch on the appliance (see page 8).
2 - Press button (D) once, twice or three times to
select the three heating element operating
modes.
- left icon on: the front heating element is on (see also
electrical system diagram fig.1 at the back of the
manual).
- left and middle icons on: the middle and rear
heating elements are on (see also electrical system
diagram fig.2 at the back of the manual).
- All three icons on: the front, middle and rear
heating elements are on (see also electrical system
diagram fig.3 at the back of the manual).
3 - Press buttons (B) and (C) to decrease or
increase the temperature set.
The preheating is automatically excluded if the set
up temperature is superior to the default one.
The temperature appears in red on the display (e6);
once the set temperature is reached, it will be
shown in green.

RESETTING THE APPLIANCE

Important
Tripping of the thermostat with automatic
reset is indicated by the flashing "ALL"
alarm on the display (B).
If the safety thermostat is tripped, the appliance
has to be restored to the initial working conditions
as follows.
1 - Leave the appliance to cool.
2 - Press button (A) to set the circuit board in
stand-by mode.
3 - Press button (A) to switch on the appliance and
start the cooking cycle.
Important
If the safety thermostat is tripped too often,
call the after-sales service.
Stopping
1 - Press button (A) to switch the appliance to
standby mode and stop the cooking cycle.
2 - Press button (A) again to switch the
appliance OFF.
3 - Turn off the appliance's circuit breaker to
disconnect it from the electrical mains.
- 9 -
IT
GB
DE
FR
ES
NL
English