Shizuoka Seiki VAL6 EPX1 Manual Del Usuario página 18

Drainage of water from the fuel tank
Remove the fuel cap and insert a suction
1
pump into the tank.
Remove as much fuel as possible (with the
2
suction pump). Be sure that the fuel being
removed is put only into a can or other con-
tainer approved in your area for holding
flammable liquids such as kerosene and
No.1 Fuel Oil.
Tighten the fuel cap fi rmly.
3
Prepare an empty container of about 3 liters
4
(0.7gallons) capacity: to hold kerosene and
water remaining in the fuel tank, place the
container under the drain bolt (of the fuel
tank).
Next, use a 24mm wrench to remove the
5
drain bolt and tilt the fuel tank until the fuel is
completely drained out of the tank. (At the
same time, be careful not to lose the drain
bolt packing.)
■ Inspection and cleaning of the fl ame monitor
• When removing the fl ame monitor, hold it by its main assembly; do not pull out the cord.
Unscrew two screws of burner cover and re-
1
move the burner cover. Pull out the fl ame
monitor and check whether or not its lens is
dirty/foul.
If the lens is dirty/foul, clean the surface of
2
the lens with a soft cotton swab or cloth until
it is clear. Do not use any cleansers of any
type, e. g., glass cleaner, to clean the lens.
Replace the fl ame monitor. Then securely
3
replace the burner cover using the provided
screws.
Lens
Cotton Swab
15
Observations
Flame Monitor
Soft Cloth
Restore the drain bolt packing and tighten the
6
drain bolt fi rmly so that fuel can not leak out
(of the fuel tank).
Wipe off kerosene or water spilled over the
7
tank and the surrounding area.
Be sure to dispose of in a safe manner as
8
approved in your local area the kerosene, etc,
placed in the empty container and the mate-
rials used to clean up any spilled kerosene,
etc. Safely clean and/or dispose of the empty
container as also approved in your local area.
Drain bolt
packing
Wrench
(24mm)
Drain
bolt
Loosen
Screw
Flame
Monitor
Pull out
Burner cover