Parts Included; Installing With Microwave - Thermador Masterpiece and Professional Series Guía Para La Instalación

Test the operation of the PTO drawer by pushing on
4.
the center lower portion of the drawer front (optimum
location for function).
Note: It should be noted the recommended and
optimum location for opening the drawer is the lower
center front. The drawer will operate with an opening
force applied to any location on the drawer front,
however a slight increase in opening force may be
required.

Parts Included

Note: The parts contained in the square tube parts box
are for microwave installations.

Installing with Microwave

Position the warming drawer housing in front of the
1.
cabinet where it is to be installed.
Position the microwave or steam oven nearby.
2.
The warming drawer is ready for the microwave to be
3.
mounted.
Pre-Assembly Preparation
Mounting the microwave on the warming drawer requires
the units to be assembled together prior to installing into
the cabinet cutout.
The 30" warming drawer is combinable with 30" built in
microwave/speed ovens. It is not combinable with the
trim kit microwaves or 27" microwaves.
Parts Provided
Universal connector
bracket (2) (in parts box).
Screws (16) (in red bag,
inside parts box).
10
Mounting the Microwave on the Warming Drawer
Note: Do not place the warming drawer into the wall
cabinet until after mounting the microwave on it using the
universal connector brackets.
Note: The universal connector brackets are
interchangeable for the left and right sides of the
warming drawer. Be sure the taller vertical edge of the
bracket is positioned to the outside of the warming
drawer.
Assemble the Brackets to the Warming Drawer
Attach both universal connector brackets to the
1.
warming drawer housing using three of the screws
provided for each bracket (A). Tighten screws
securely, but do not over tighten.
Note: The existing screws in the microwave base help
with alignment. When lowering the microwave into
place on the universal connector bracket allow these
screw heads to slide into the slots as shown in the
illustration below. The screw nearest the front of the
microwave slides into the base of the slope at the font
of the bracket.