Remove Shipping Brackets - Thermador Masterpiece and Professional Series Guía Para La Instalación

Remove Shipping Brackets

Remove the ten (10) screws fastening the shipping
brackets from the housing.
The lower bracket screws can be accessed by turning
the housing on end or sliding forward off the surface
table to gain access to the lower screws and bracket.
A moderate force may be required to pry the top and
bottom outer bracket from the side of the housing since
the screws tend to slightly deform the housing hole
causing slight binding of the bracket.
Note: Take care not to damage or scratch the front
stainless steel cover or side trims.
Discard the two outer and inner shipping brackets and
the ten (10) screws that were just removed. They are no
longer needed for the installation.
14
Slide the housing into the cabinet opening until the side
trims touch the cabinet face. There is a v-notch on the
top face of the stainless steel front cover to assist in
alignment of the housing to the cabinet opening.
Measure the cabinet opening and adjust the storage
drawer housing by aligning the v-notch with half of the
measured cabinet opening. This will ensure the housing
is centered in the opening.
Once the storage drawer has been aligned to the cabinet
opening, install two (2) supplied screws to secure the
housing to the cabinet face.
With the drawer fully open, drill pilot holes through side
flange with a 1/8" (3.175mm) wood bit before the steam
oven or drawer is installed.