Thermador Masterpiece and Professional Series Guía Para La Instalación página 16

Position the drawer assembly in front of the housing
2.
assembly and align the rail to the slide ball carrier
assembly. Keeping the drawer assembly level and
square to the housing, gently insert the drawer to the
housing assembly.
Notes
A slight side-to-side wiggle motion may be required
▯
to properly get the ball bearings to accurately align.
Remember: You are attempting to align two sets of
▯
ball bearings. If more than a moderate force is
required to insert the drawer at this time, remove the
drawer and repeat the installation procedure to this
point.
Continue to insert the drawer keeping the drawer level
3.
and square to the housing until a slight increase in
resistance is felt at the approximate position shown
below.
NOTICES
At this position, a slight increase in closure force is
▯
required with several small increments of force
applied to the drawer to accurately align and set the
drawer for proper operation.
An audible "click" will be heard when the drawer is
▯
properly closed causing the drawer to lock in the
closed position.
16
Test the operation of the PTO drawer by pushing on
4.
the center lower portion of the drawer front (optimum
location for function). The drawer will operate with an
opening force applied to any location of the drawer
front when outside the recommended location with a
slight increase in force.