Transport, Storage & Disposal; Transport; Storage; Disposal - HOLZMANN MASCHINEN PSM 2 Manual De Instrucciones

TRANSPORT, STORAGE & DISPOSAL

16.1 Transport

Due to its heavy weight, never lift the machine alone, but always in pairs!
For transport, only hold the machine by the holders provided.
Only transport the machine in an upright position!
Secure the machine against slipping during transport.

16.2 Storage

Never store the machine in damp rooms, but only in dry rooms!
During prolonged storage, make sure that the rollers and grinding wheel do not come into contact
with the ground. For this purpose, store the machine on two supports with a height of at least 20
mm.

16.3 Disposal

Observe national waste disposal regulations. Do not dispose of the machine,
machine components or operating materials in residual waste. If necessary,
contact your local authorities for information on available disposal options.
If you buy a new machine or an equivalent machine from your dealer, he is
obliged in certain countries to dispose of your old machine properly.

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine will not start
Poor polishing performance
Scratches on the work
surface
Poor dust extraction
Burns on the working
surface
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
HOLZMANN MASCHINEN GmbH
Possible cause
 Switch defective
 Power supply is off
 Fuse is defectivet
 Electric contactor is defective
 Unauthorized or worn abrasive
 Insufficient pressure of drum
 Insufficient V-belt tension
 Worn V-belt
 Wrong abrasive
 Drum surface dirty or damaged
 Dust bag for more than 1/3 filled
 Dust bag dirty
 Worn or fine abrasive
 Too high drum pressure
www.holzmann-maschinen.at
TRANSPORT, STORAGE & DISPOSAL
Solution
 Repair switch
 Repair power supply
 Change fuse
 Repair or change electric
contactor
 Change abrasive
 Increase drum pressure
 Tighten V-belt
 Change V-belt
 Change abrasive
 Clean or change drum
 Empty dust bag
 Wash the dust bag
 Change abrasive
 reduce drum pressure
25
PSM2 / PSM3