User Interface And Navigation - Hach Event Monitor Trigger System Manual Básico Del Usuario

Connect to a SCADA system (optional)
The ADAM isolated RS485 MODBUS output (J12 terminal) can be used to connect a SCADA system
to the monitor. Make the applicable connections to the RS485 terminal (pins OUT – and OUT +).
Refer to General wiring procedure
Connect the optional WDMP circuit board
To connect the monitor to an original WDMP, install the optional WDMP circuit board in the monitor
enclosure. Then, connect the WDMP communication cable to the circuit board. Refer to
wiring procedure on page 9 and
Figure 5 WDMP circuit board wiring
1 Optional WDMP circuit board
2 White wire
Install the plugs
The enclosure rating is only valid when plugs or closed strain-relief fittings are installed in the wire openings.
Install the supplied plugs in open (unused) wire openings. Make sure that the round, flat surface of
the plug is against the external surface of the enclosure.

User interface and navigation

Display description
Figure 6 shows the Main Menu screen.
screen.
on page 9 and Figure 4
Figure 5.
3 Green wire
4 WDMP communication cable
N O T I C E
Table 4 gives descriptions of the different areas of the
on page 10.
General
English 11