Installing The Base - Be Cool ONE Manual Del Usuario

1. INSTALLING THE BASE

To install the ONE child restraint system, follow the
steps below:
Attach the anti-swivel system (3) it will click into
1a.
place
1b. Unfold the leg (13) until it is in the vertical position
as shown.
1c. Move the button (15) to slide the ISOFIX (14) bac-
kwards until the connector is completely unfolded. Do
the same operation for both connectors.
1d. Guide the connectors towards the ISOFIX anchors in
your vehicle until they click into place and the indicator
changes from red to green on both sides of the
Push the seat backwards pressing it against the
1e.
backrest of the vehicle seat. Then try to pull the seat
towards you to make sure that it is correctly secured
in place.
1. INSTALACIÓN DE LA BASE
IM 2041,00 ONE instruc ok.indd 25
1f. Press the button (12) to adjust the height of the
support leg (13) to ensure that it is touching the floor.
It should not be placed on top of any type of compart-
ment. At this point make sure that the position of the
support leg is at an angle of 90o from the seat base.
The visual ISOFIX indicators will show whether the con-
nector is closed or open. It may be that the connector
is closed without being secured in the ISOFIX anchor.
Please check this by pulling the seat once the connec-
tors are correctly locked into the vehicle anchors.
To remove the seat, follow the same steps in reverse
order:
1g. Move the button (10) to open the connector and
release the anchors.
base.
EN
25
31/1/19 16:52