Tare And Zeroing; Summing Function; Hold Function; Energy Saving - Baxtran STX Serie Manual De Usuario

5.3 TARE AND ZEROING

To tare, place the weight to be tared on the hook. Once the weight is stable, press the
weight will be saved in the hook's memory. Press
If there is nothing hanging on the hook, the weight should be zero. If it shows any other value while empty, use the
the B button on the remote to set it to zero.

5.4 SUMMING FUNCTION

When the display reading is stable and the weight exceeds 20 divisions, press the C button on the remote to sum up the measures. By pressing
the C button after each weighing, the display will show the number of measures ("n32"), and after 2 seconds the hook will return to the normal
weighing mode.
To display the previous weight, as well as the previous total weight, press the A button at any time. To cancel the summing function, press the
B button on the remote to return to the normal weighing mode

5.5 HOLD FUNCTION

Press the D button on the remote to fix the reading on the display for 30 seconds.
Press the D button on the remote again to turn off the Hold function and enter normal weighing mode.

5.6 ENERGY SAVING

If the hook remains at zero and inactive for one minute, the display will go blank, depending on the battery saving setting (there will only be
one dot at the bottom of the display). As soon as weight is loaded onto the hook or a button is pressed, the display will return to showing the
current load value.

5.7 REMOTE CHANNEL SELECTION

1. With the hook off, press the keys
2. Press the key
3. Now the display will show "CHX" ("X" representing the current channel "0-7" )
4. Press key to select a channel and then press
5. The display will show "Ft0 ". (Command configuration). Keep in "0 "
6. Keep at "0 ". Press
Note: The channel is already configured with the corresponding control for each hook. Only configure couando the control is
controlled

6. CALIBRATION

1. Switch on the hook and, during initialisation, press and hold down the
A
2. If you press the
the display will briefly show "------" and finally "
D
3. Press the button on the remote control to enter the value of the calibration weight. Press the
to increase the value selected and press
4. Hang the calibration weight and wait a few seconds until the stability indicator lights up.
A
5. Press the button on the remote control, the display will briefly show "------" and finally show the weight value. Remove the weight,
switch off the hook and switch it back on to test it.
12
y
to go to the next option.
to return the weighing mode and restart the device.
button on the remote control, the display will show "
D
once to change between digits.
to remove the tare.
at the same time. The display will show: "Dsp X". (function not available)
to go to the next option
D
button on the remote to display "
CAL 00
LOAD
".
USER'S MANUAL STX
button or the B button on the remote and the
CAL SP
" when it has no load on the hook; press the A button and
C
button once, or hold down the
EN
hook button or
".
D
button