Whirlpool 7MWFC9822HC1 Manual De Uso Y Cuidado página 17

WASHER/DRYER CARE (cont.)
2. Chlorine Bleach Procedure:
a. Open the washer/dryer door and remove any clothing
or items.
b. Open the single-load dispenser drawer and add regular
liquid chlorine bleach to the "MAX" line in both the bleach
compartment and the fabric softener compartment. Either
traditional or HE chlorine bleach can be used.
IMPORTANT: Do not use thickened, easy-pour,
or no-splash bleach as excess suds may occur.
NOTE: Use of more liquid chlorine bleach than is
recommended above could cause washer/dryer
damage over time.
c. Close the washer/dryer door and the dispenser drawer.
d. Do not add any detergent or other chemicals to the
washer/dryer when following this procedure.
e. Select the Clean Washer with affresh
f. Select the FanFresh
interior after the cycle is complete.
NOTE: The washer/dryer remembers your last option
selection and will use it for future wash cycles until you
deselect that option.
g. Touch and hold START/PAUSE to begin the cycle.
The Clean Washer with affresh
is described below.
NOTE: For best results, do not interrupt cycle.
Description of Clean Washer with affresh
1. The Clean Washer with affresh
clothing or other items are in the washer.
2. If no items are detected in the washer, it will proceed with the
cycle.
a. If any items are detected in the washer, "rL"
(remove load) will be displayed. The door will unlock. Open
washer/dryer and remove any garments from the washer/
dryer drum.
b. Touch POWER to clear the "rL" code.
c. Touch and hold START/PAUSE to restart the cycle.
3. After the cycle is complete, leave the door open slightly to
allow for better ventilation and drying of the washer/dryer
interior.
cycle.
®
option to help dry the washer/dryer
®
Cycle operation
®
Cycle Operation:
®
cycle will determine whether
®
WASHER/DRYER CARE (cont.)
Cleaning the Dispensers
After using the Clean Washer with affresh
find some residue buildup in the washer/dryer's dispensers.
To remove residue from the single-load dispenser, remove
the drawer and wipe the surfaces with an affresh
Cleaning Wipe or a damp cloth and towel dry either before
or after you run the Clean Washer with affresh
an all-purpose surface cleaner, if needed.
To remove residue from the Load & Go bulk dispenser, lift the
handle on the dispenser housing and pull to remove it from
the washer/dryer cabinet; then rinse the dispenser thoroughly
with running water. Wipe the outside dispenser surface with
an affresh Machine Cleaning Wipe or a damp cloth, and
®
towel dry. Use an all-purpose surface cleaner, if needed.
Replace the dispenser in the washer/dryer cabinet and make
sure that it is correctly seated.
IMPORTANT: Dispensers are not dishwasher-safe.
Cleaning the Outside of the Washer/Dryer
Use an affresh Machine Cleaning Wipe or a soft, damp
®
cloth or sponge to wipe up any spills. Occasionally wipe the
outside of your washer/dryer to help keep it looking new. Use
an affresh Machine Cleaning Wipe or mild soap and water.
®
IMPORTANT: To avoid damaging the washer/dryer's finish,
do not use abrasive products.
CLEAN WASHER CYCLE REMINDER
The Clean Washer with affresh
end of a wash cycle when the washer/dryer has run 30 wash
cycles. This is a reminder to run the Clean Washer with
affresh cycle.
®
If the Clean Washer with affresh
message will stop flashing at the end of a wash cycle
after running three more regular wash cycles. After 30 more
wash cycles are completed, the Clean Washer with affresh
message will again flash at the end of a wash cycle as a
reminder.
cycle, you may
®
Machine
®
cycle. Use
®
message will flash at the
®
cycle is not run, the
®
®
17