U.S.Robotics SureConnect 9106 Manual Del Usuario página 7

2. Follow the on-screen instructions to complete the software installation.
3. A qualification test will run to verify that your system meets the minimum
requirements for installation. The Results screen will display those items in
your configuration that passed with a green flag and the ones that failed
with a red flag. If your system passed the qualification, click Next.
If your system fails the qualification test, click View Report to identify
which component(s) failed. For additional information, refer to the
Troubleshooting section of this installation guide.
Step 3. Install the Antennas and Cables
1. Attach the antennas to the back of the gateway.
2. Plug the AC power adapter into the 16VAC jack on the back of your U.S.
Robotics SureConnect
into a standard wall outlet. If the PWR LED on the front panel is not
illuminated, press the Power switch on the back of the gateway.
The gateway will initialize after the power is turned on. This process may
take a moment.
For Windows Users only: Click Next. The necessary files will be copied to
your system.
3. Connect one end of the included grey telephone cable to the grey
telephone port on the back of your gateway labelled ADSL. Connect the
other end into the telephone wall jack. For Windows Users only: Click
Next.
4. Select one of the following connection options.
Via a wireless connection:
Scan for the Wireless Gateway and associate to it. For Windows Users
only: Click Next.
ADSL Wireless Gateway. Plug the AC power adapter
5
5