Water Condensation Drainage - Honeywell HL10 Serie Manual Del Propietário

WATER CONDENSATION DRAINAGE

WATER CONDENSATION DRAINAGE
When there is excess water condensation inside the unit, the air conditioner stops running and shows a
warning light (the WATER FULL indicator illuminates with a red light). This indicates that the water
condensation needs to be drained using the following procedures:
Manual Draining for Cooling, Heating* & Dehumidifier Mode
Water may need to be drained in high humidity areas.
1. Unplug the unit from power source.
2. Place a shallow pan under the lower rubber drain plug.
See diagram.
3. Remove the rubber drain plug.
4. Water will drain out and collect in the shallow pan.
5. After the water is drained, replace the rubber drain plug.
6. You can now turn on the unit.
Continuous Draining for Dehumidifier Mode
While using the unit in dehumidifier mode, continuous
drainage is recommended.
1. Unplug the unit from the power source.
2. Remove the upper/lower rubber drain plug. Some
residual water may spill so please have a pan to
collect the water.
3. Connect the drain tube (included) to the upper or
lower drain (whichever is more convenient for your
space). See diagram.
4. The water can be continuously drained through the
drain tube into a floor drain or bucket.
5. Replace the drain plug.
6. You can now turn on the unit.
Shallow Pan
(Not included)
*Applicable for models with Heating feature only.
EN 9
Lower
Rubber Drain
Plug
Upper Rubber Drain Plug
Drain Tube (included):
Dia. 0.09" (0.22cm)
Length: 29.3" (74.5cm)