Honeywell HL10 Serie Manual Del Propietário página 4

INSTALLATION
It is important that the installation instructions below are followed for successful installation of this
portable air conditioner. Please call Customer Support if you have any difficulties or queries regarding
these installation procedures.
Installation Kit:
1. Window Bracket Kit.............................
2. Window Bracket Panel Adapter..........
3. Plastic Pin............................................
4. Hose Connector..................................
5. Plastic Hose........................................
6. Drain Tube (refer to Continuous
Draining for Dehumidifier Mode)..........
Installation Steps:
1. Locate and snap the 2 half pieces of the Window Bracket Panel Adapter securely together. Install
onto the plastic hose by rotating anti-clockwise over the plastic hose. Install and rotate (anti-clock-
wise) the hose connector over the opposite end of the plastic hose. Ensure secure fit on both ends.
2. Adjust the window bracket as per width or
height of your window and insert the plastic
pin to fix at the desired position. There is a
hole where the Plastic Hose will be inserted
later. Make sure this hole is not blocked.
26.6", 33.1" to 49.6"
(67.5cm, 84cm to 126cm)
Note:
After setting the window bracket to the size of your
window, please remove it from the window and
follow the instructions below.
4. Connect the window bracket to the window
bracket panel adapter. Ensure that all
connections are tight and installed properly.
1 Set
2 Half Pieces
1 Piece
1 Piece
1 Piece
1 Piece
Plastic Pin
Hole for Window Bracket
Panel Adapter & Plastic Hose
1
x 1
5
=
3. Connect the plastic hose to the hose
connector on back of the unit. Slide-in the
hose connector downwards until it is locked
in place.
Plastic Hose:
Dia. 5.9" (15cm)
Length: 14.2" to 47.2" (36cm to 120cm)
5. Connect the window bracket to the window.
6. The Portable Air Conditioner is now ready to use.
EN 3
2 3
x 2 x 1
6
x 1
4
x 1
x 1