Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
ASSEMBLY INSTRUCTIONS
Assembly of the front (bigger)
Make sure the front fork of
wheel: open the quick-release
the scooter is well positioned
lever and loosen the nut.
(disc brake is on the left side in
rider´s view).
Assembly of the rear wheel is
Installation of brake cables:
the same as the assembly of the
press the brake lever to the maxi-
front wheel. Repeat the same
mum and insert the ending of the
process.
brake cable into the circular fixing
point. Repeat the action with
both brakes.
the right, front brake cable on the left.
18
18
Place the wheel into the front fork
so that is well-centred.
The tread pattern (arrow-shaped lines
on the tires) must be pointing to the front.
Adjustment of brake levers:
incline the brake levers correctly
by loosening the screw on the
sleeve.
The right inclination: stand on the
footboard, hold the handles and stretch
out your fingers in a way that your arm and
The rear brake cable is usually fixed on
the fingers form a single straight line. This
should be the position of the brake levers.
Handlebar installation: place
Tighten the nut
(1)
until you can
feel resistance before closing the
the handlebar tube as shown
quick release. Close it in a way
on the picture and tighten the
that the quick release lever
(2)
screws on the stem.
points backwards (for safety
reasons).
Adjustment of brakes: on both
The distance between the pads
wheels, check that the discs are
and the disc should be minimal.
not touching the brake pads
You can adjust it with the adjus-
when the wheel is turning. If
ting roller
yes, loosen the adjusting screws
tension of the brake cable. If this
(1)
and regulate the position of
is not enough, tighten or even
both brake pads so that they are
loosen the brake cable at the
parallel to the disc on their whole
anchor screw (2).
length. Then tighten the screws
again.
Insert the handlebar tube into the
front frame
(1)
and adjust the height
according to the rider's needs
(not higher than indicated by the
line). Check that the handlebar is
upright and properly tighten the
screw on the handlebar tube (2).
(1)
which regulates the
19
19
Publicidad
Tabla de contenido
