Wind Speed And Direction - Bresser ClimaTemp FW + Multisensor-Set Manual De Instrucciones

• ABSOLUTE: the absolute atmospheric pressure of your location.
• RELATIVE: the relative atmospheric pressure based on the sea level.
Set relative atmospheric pressure value
4. Get the atmospheric pressure data of the sea level (it is also the relative atmospheric pressure
data of your home area) through the local weather service, internet and other channels.
5. Hold the BARO button for approx. 3 seconds, until ABSOLUTE or RELATIVE flashes.
6. Press the UP or DOWN button to switch to RELATIVE mode.
7. Press the BARO button again, and the number for RELATIVE flashes.
8. Press UP or DOWN button to change the value.
9. Press the BARO button to save and exit the setting mode.
NOTE
10. The default relative atmospheric pressure value is 1013 mb/hPa (29.91 inHg), which refers to the
average atmospheric pressure.
11. When you change the relative atmospheric pressure value, the weather indicators will change
along with it.
12. The built-in barometer can notice the environmental absolute atmospheric pressure changes.
Based on the data collected, it can predict the weather conditions in the forthcoming 12 hours.
Therefore, the weather indicators will change according to the detected absolute atmospheric
pressure after you operate the clock for 1 hour.
13. The relative atmospheric pressure is based on the sea level, but it will change with the absolute at-
mospheric pressure changes after operating the clock for 1 hour.

25 Wind speed and direction

Reading the wind direction
Wind direction indic-
ator
Select display mode
Press the WIND button several times until the desired rate is displayed:
• AVERAGE: average of all wind speed numbers recorded in the previous 30 seconds
30 / 80
Meaning
Real-time wind direction
Wind directions appeared in the last 5 minutes (max. 6)