Getting Started - EASYHOME 3285 Manual Del Usuario

Quilted Heated Mattress Pad

Getting Started

GETTING STARTED
Step 1: Remove the product from the package along with the controller(s).
Step 2: Lay the mattress pad out flat on the bed, with the connectors placed at the foot
of the bed. The label should always be facing UP toward the ceiling, at the foot of the bed.
When using a throw, the connector should be located at your feet with the label facing UP.
Step 3: Securely attach the connector cord from the controller to the connector on the
product. Make sure that the connection is firmly secured. If you have a Queen or King
sized product it is not necessary to connect both sides for the product to operate proper-
ly; however you will only receive heat to the side of the product that is properly connect-
ed. NOTE: It does not matter which controller is attached to which side of the product, the
controllers are interchangeable.
Step 4: Insert power cord into standard 120 volt wall outlet.
CAUTION! Do not route electrical cords between the mattress and box spring.
Do not allow the cords to be pinched, trapped, or crossed. See Safety Instructions.
CAUTION! Do not tuck in the wired area of this bedding. See Safety Instructions.
CAUTION! Do not cover the controller. See Safety Instructions.
Proper orientation of the mattress
pad is critical. This mattress pad
contains dual zone warming areas
which provide additional heat at
the foot of the matress pad.
After Sales Support 5
800.789.6441 cs1@biddefordblankets.com