Remote Sensor; Getting Started; Insert Batteries - Oregon Scientific Jumbo Manual De Usuario

REMOTE SENSOR

19
19. LED status indicator
20. Wall mount hole
21. TX: Reset the unit to default settings
22. Battery compartment

GETTiNG STaRTED

iNSERT baTTERiES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (+/-).
3. Press RESET after each battery replacement.
JW108_M_EN R1.indd 3
20
22
21
TX
REMOTE SENSOR
The main unit can collect data from up to 1 sensor.
To set up the sensor:
1. Open the battery compartment.
2. Press TX.
3. Close the battery door.
4. Place the sensor within 98 ft (30 m) of the main unit
TiP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 5 ft (1.5 m) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
3
MEaNiNG
LOCaTiON
Clock area Main unit batteries
low
Outdoor temperature ensor batteries low
area
using the wall mount.
14-8-21 3:05