Electrical Installation; Mechanical Installation - MicroPower Sharp 30 Instrucciones De Uso

Warning
Risk of explosion!
Do not smoke, cause sparking or use open flames
near battery.
Arcing could cause injury to the operator or
damage the battery connector.
Always stop the charging process by pressing the
STOP button before the battery is disconnected.
Do not keep inflammable material close to battery
charger.
Make sure the charging parameters are correctly
set according to the battery manufacturer
specification, see Parameter settings.
Charging may only be performed in a
well ventilated environment.
Receiving
On receipt, visually inspect the product for any
physical damage. If necessary contact the
transport company.
Check the delivered parts against the delivery
note. Contact your supplier if something is missing,
see Contact information.
Installation

Mechanical installation

• Install the battery charger indoors in a dry, clean
and well ventilated environment.
• Comply the dimensions specified for free space
around the battery charger, see Figures
depending on model.
• Install the battery charger so that gases from
the battery charging process are not sucked in
by the battery charger fans.
1. Attach the battery charger to a wall or similar
using the accompanying bracket.
The battery charger is installed vertically and
can be secured with screws.
Caution
The battery charger should always be securely
fastened.
4

Electrical installation

Warning
High voltage!
Incorrect connection of battery cables can cause
personal injuries and damage to the battery,
battery charger and cables.
Make sure the connections are correct.
The battery charger is produced for different mains
voltages.
2 Check that the power supply at the site of the
installation complies with the rated voltage
specified on the battery charger's data label.
The label is located on the left or lower side of
the charger.
Warning
High voltage!
Risk of live chassis.
Always connect the charger to a power outlet with
protective earth.
The charger is normally equipped with:
• Fixed mains cable with connector at higher IP
rating.
• Detachable mains cable set at lower IP rating.
The charger is normally delivered with a battery
cable with the following polarity:
• Positive (+) = Red
• Negative (-) = Blue or Black
3 Check the polarity of battery connector and
cable before connecting the battery.
4 Connect the battery charger to the battery.
Operation
User interface - Control panel
See Fig. 1 Control panel
1. Control panel
2. Alarm indicator (red)
3. Charging indicators (green and yellow)
4. Mains power indicator (blue)