Daewoo International DTC-310 Guia Del Usuario página 23

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SETTING RINGING TONE AND ADJUST RINGING VOLUME
There are 16 kinds of ringing tones and RING OFF for selection:
1. In on-hook state, press HOLD key, LCD displays ring 02 db8
2. Press HOLD to select the desired ringing or set ring OFF
3. Press UP or DOWN key to set ringing volume-
4. Press SET to confirm and exit.
NOTE: The volume ranges from 1db-8db, with 8db being the loudest. Ring OFF is "Do Not
Disturb" mode. If the phone is set to this mode, the telephone will not ring when there is an
incoming call.
Besides,you can slide the ringing volume switch to HI or LOW to select desired ringing volume.
BABYCALL FUNCTION
At on-hook state, press and hold REDIAL key for 3 seconds to come into baby call function setting.
LCD displays BABYCALL OFF, press REDIAL key to set it ON, press SET key. LCD displays
NO CODE (or the preset baby call number, press DEL key to cancel), input baby call number
using numerical key and press SET key to confirm.
After set baby call function to ON state, pressing any key except REDIAL key or picking up
handset will dial out the baby call number automatically.
When baby call function is ON state, you can still answer the incoming call.
NOTE: If you don't use the function, enter baby call function setting as per above operation and
select BABYCALL OFF, press SET key to confirm.
ANTI-DIALING FROM PARALLEL PHONES FUNCTION
1. In on-hook state, press and hold # key for 3 seconds, LCD displays SPI ON
2. Press SPEAKER key twice and then
3. Press and hold # key for 3 seconds again, LCD displays SPI OFF
When the anti-steal dialing is set to ON, users who want to dial using an extension via the same
line will hear a "DI-DI, DI-DI" beep continuously and will not be allowed to make a call.
ADJUST HANDSFREE VOLUME
In handsfree state, press UP or DOWN key to adjust the handsfree volume, LCD displays the
volume level, total 4 steps.
SETTING PULSE OR TONE DIALING MODE
1. In on-hook state, press and hold * key for 3 seconds, LCD displays P, then dialing mode is set
as Pulse.
2. Press SPEAKER key twice and hold * key for 3 seconds again, LCD displays T, then dialing
mode is set as Tone.
23

Publicidad

Tabla de contenido
loading

Tabla de contenido