Opex Falcon+ Manual Del Operador página 270

A.1.4. Performance Details Statistics
The following table list the terms that appear in the Performance Details
section of the statistics report.
Note: All times noted in the formulas in this table are in seconds. For example,
if the Active Job Time appears as "00:01:49" then that means one minute
(60 seconds) plus 49 seconds, or 109 seconds.
Table 3: Performance Details terms
Term
Active Job
Time
Run Time
Jam Time
Idle Time
The Rejects section lists the reasons for the rejected items and how many
items were rejected for each reason.
Table 4: Reasons for rejected items
Length Too
Long
Length Too
Short
Gap Too Small
Too Thin
Too Thick
Definition
Time the Falcon+ was either actively running or was halted
due to a jam. Active Job Time is broken down by:
• Run Time
• Jam Time
Total run processing time.
Total time the Falcon+ was halted for a jam.
Time the Operator was in the Run Job window, but the
Falcon+ was not processing pieces.
Results when an image is longer than the maximum
allowable image size of the system or when outsorting is set
to reject an image longer than a defined length.
Results when outsorting is set to reject an image shorter
than a defined length.
Results when the gap between pieces is shorter than the
minimum feed gap defined in the machine parameters.
Results when out sorting is set to reject a piece thinner than
a defined minimum allowable thickness.
Results when out sorting is set to reject a piece thicker than
a defined maximum allowable thickness.
Falcon+ Operator Manual
OPEX Corporation
135