Opex Falcon+ Manual Del Operador página 274

Table 4: Reasons for rejected items (continued)
Last
Transaction
Not Complete
Current
Transaction
Already
Complete
Batch Ticket
Not Expected
Ran Out of
Time
Processing
Image
Could Not
Detect
Document
Edges
No Page Sub-
Type Selected
ScanLink
Plug-in
Requested a
Reject
ScanLink
Plug-in Timed
Out
Could Not
Create a Batch
Detected a
Duplicate
Batch
Results when the current transaction does not fit the defined
transaction criteria and a piece is identified as a page type
that defines a new transaction.
Results when a transaction has met its defined criteria and a
new piece that is not defined to start a new transaction is
identified.
Results when a piece is identified as a batch ticket after
valid pieces are already included in the batch unless auto
batch mode is in use.
Results when the software has run out of the time that it has
available to process a particular image. The amount of time
it has available depends upon track speed.
Results when image processing is unable to detect the
edges of an item that has been scanned.
Results when a piece is identified as one with page sub-
types and no default page sub-type has been specified and
the operator did not make a page sub-type selection.
Results when the ScanLink plug-in has requested that the
piece be rejected.
Results when the host has not received a response back
from the ScanLink Plug-in within the required amount of
time.
Results when the software was unable to create a batch due
to an inability to open and write a new file or an error within
the system.
Results when the software has detected a duplicate batch
either via the used batch list or by finding batches in the
batch directories with the same batch number.
Falcon+ Operator Manual
OPEX Corporation
137