Installing The Appliance - Blaupunkt 5CB 28010 Montaje Y Modo De Empleo

Start-up

Installing the appliance

Prior to installation, check whether the
door hinge is on the correct
side. If necessary, change the door hinge
(see "Changing the door hinge" on page 49).
For the installation, you will require a PH2
Phillips screwdriver.
1. Switch off the fuse for the designated
socket. Then plug the power plug into the
socket.
2. Slowly and cautiously push the
refrigerator into the built-in cabinet.
When doing this, ensure that the side to
be opened is located as close to the
cabinet wall as possible.
(24)
(18)
3. Holes are pre-drilled in the outer edges
of the appliance doors for attaching the
sliders (18). Screw 2 sliders per door to
the sides to be opened using the short
screws (24).
4. Push the drag rails (20) into the sliders
(18). Close and open the cabinet doors
to check whether they can be closed
completely and easily.
If necessary, correct the position of the
refrigerator.
5. Open the doors of the appliance and the
cabinet at the same time. Then mark the
optimum positions of the drag rails
inside the cabinet doors.
6. Remove the drag rails from the sliders.
7. Screw the drag rails to the marked
positions on the insides of the cabinet
doors using 2 short screws (24) each.
8. Press the covers (21) onto the drag rails.
9. Unscrew the sliders again and push
them on the attached drag rails.
10. Screw the sliders to the refrigerator
door again.
11. Press the covers (19) onto the
sliders.
12. Check whether the doors open and
close smoothly and whether the
( )
20
refrigerator doors close tightly. If
necessary, adjust the standing position
of the refrigerator and the position of
the sliders and drag rails.
Page 47
(20)
(24)